I'm the dummy.
My Evinrude 25 hp. I haven't run in a yr. prior- it was serviced by Sport Marine, then run for a week.
I replaced gas. Blew out gas lines. Bled gas out of carbs.
Started up on first pull. Ran very well. Ewngaged throttle forwaard and back. Was perfect. After ten minutes I shut down and then went to start again. Ran well with primer up but once I lowered the primer on the throttle to put into gear, it began stalling.
It still runs and sounds great for a long time at a little bit higher idling speed but once that is lowered to engage the prop, it stalls.
Am I looking at a screwdriver adjustment or another carb job?
Or, should I just run that new gas through there for a longer period before I take it to the shop for work?
My Evinrude 25 hp. I haven't run in a yr. prior- it was serviced by Sport Marine, then run for a week.
I replaced gas. Blew out gas lines. Bled gas out of carbs.
Started up on first pull. Ran very well. Ewngaged throttle forwaard and back. Was perfect. After ten minutes I shut down and then went to start again. Ran well with primer up but once I lowered the primer on the throttle to put into gear, it began stalling.
It still runs and sounds great for a long time at a little bit higher idling speed but once that is lowered to engage the prop, it stalls.
Am I looking at a screwdriver adjustment or another carb job?
Or, should I just run that new gas through there for a longer period before I take it to the shop for work?
Motors for Dummies
Aucun commentaire:
Enregistrer un commentaire