I am attempting to cut the shaft down on my Minn Kota trolling motor, but I am having trouble getting the hole re-drilled. This is the hole that the head mounts to. Obviously I want it clean and tight or the head will move around.
I can't get the holes straight, and the fiberglass is so thick that you get no play whatsoever. I have attempted twice now with no success. Plus is have to keep from cutting the wires that are still in the shaft.
Any one have openly trick to get a hole straight through the shaft? Would be much easier if I could take it off and put it one my drill press, but this is still on the boat.
Thanks guys.
Sent from my iPad using Tapatalk
I can't get the holes straight, and the fiberglass is so thick that you get no play whatsoever. I have attempted twice now with no success. Plus is have to keep from cutting the wires that are still in the shaft.
Any one have openly trick to get a hole straight through the shaft? Would be much easier if I could take it off and put it one my drill press, but this is still on the boat.
Thanks guys.
Sent from my iPad using Tapatalk
Aucun commentaire:
Enregistrer un commentaire